Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Timmer71

Pages: [1]
1
Super 9 / Re: Ignition Switch wiring - Need Help!
« on: August 11, 2011, 02:53:18 AM »
Well, I finally figured it out. Here is a pic in case someone else out there is in the same boat I was. I'm not 100% sure this is factory correct but it works. When the ignition is in the "on" position the black and red are connected. When the key is in the "off" position the Blue/yellow (pulsar coil) and greens (ground) are connected.


By timmer_71 at 2011-08-10

2
Super 9 / Re: Ignition Switch wiring - Need Help!
« on: August 03, 2011, 12:05:22 AM »
Thanks, but I'm not sure that would help me figure out exactly where I'm supposed to solder each wire on to the back of the ignition. I have a copy of the shop manual but it doesn't show me exactly what I need.

3
Super 9 / Ignition Switch wiring - Need Help!
« on: August 02, 2011, 02:06:42 AM »
Hello all, I just bought a used Kymco Super 9 LC. It is in pretty rough shape and the wiring has been hacked up. I have the key and the ignition is still in place but the wires have been pulled out and I dont know what to solder where. Does anyone have a picture of the back of there ignition where I can see what wire is soldered to where? Here is a pic of what I have (hopefully this works)


By timmer_71 at 2011-08-01



Pages: [1]