Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bus Man

Pages: [1]
1
zx50 / Re: Oil leak from oil level sending unit
« on: December 21, 2023, 03:39:47 AM »
Picture doesn't really show anything just oil leaking on top of oil tank coming from sending unit because when full the oil level is higher that oil level sending unit.
Looking for a place to purchase new sending unit but have not found in stock anyplace. Part number is 35410-GR1-9000

2
zx50 / Oil leak from oil level sending unit
« on: December 19, 2023, 08:45:38 PM »
I posted this in Tech section but didn't know if everyone saw it there.  My ZX50 has oil leaking out I think from top of the sending unit on oil tank.  I would buy a new one but can't find one online.  Wonder if I can seal top with silicone including where wires come out.  Anyone do something like that. 

3
Technical | How To / Re: oil level sending unit leaking on ZX50
« on: December 18, 2023, 08:52:09 PM »
don't have pic but it is the seal where sending unit pushes into oil jug or out the top of sending unit

4
Technical | How To / oil level sending unit leaking on ZX50
« on: December 18, 2023, 06:05:45 PM »
Oil leaking from sending unit any way to fix it?

5
Technical | How To / Re: Adjust Oil injector on ZX 50
« on: September 14, 2011, 04:49:03 PM »
Thanks for the help, I'll take another look when I get time.

6
Eye Candy | Videos and Pics / Re: my crashed S8
« on: September 12, 2011, 07:30:54 PM »
I used a fiberglass repair kit on the back side of the panel then body filler on the front. Now it's stronger than when new.

7
Technical | How To / Re: Adjust Oil injector on ZX 50
« on: September 06, 2011, 01:56:00 PM »
You say the arrow is on the lower side.  Do you mean on the tab that goes down the side?  I'm looking from the top with just the seat and storage compartment removed so I can't see from the side.  I do see the casting marks.  Thanks              Bus Man

8
Technical | How To / Adjust Oil injector on ZX 50
« on: September 02, 2011, 04:01:28 PM »
I'm fairly new to my ZX 50 scooter and need to know how to adjust the oil injection. The manual talks about marks where the cable is attached. I see three points in the casting on the lower part but no marks on the disk like part that moves unless what I think is a 1 with other numbers is an arrow. Can anyone explain it to me.   Bus Man

Pages: [1]