Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - randy50

Pages: [1]
1
Technical | How To / Re: People 50 hop up next step
« on: February 27, 2012, 08:21:35 PM »
Drilled out the idle jet today to .35mm. Installed the open air filter and after a little adjusting the bike runs fine. Its louder than it was with the stock air filter but its worth it because of the power increase. Man these engines are touchy.
Thanks for your help.

2
Technical | How To / Re: People 50 hop up next step
« on: February 27, 2012, 11:52:49 AM »
Thanks Zombie, Didnt know I would have to experiment with the Idle jet also. Im sure its small but dont know the exact size. Gonna order some main and idle jets of various sizes and play.

3
Technical | How To / People 50 hop up next step
« on: February 26, 2012, 11:05:13 PM »
Ok guys after reading a lot of post I decided to post my first. I have a people 50 with 900 km. Im in to the derestricting thing. I replaced the variator shaft which was a big plus. Next I increased the main jet from .65 to .90mm. It will run good with this set up with the air/fuel screw all the way in.
I installed a K&N style open air filter and the engine run very badly but runs fine when I install the factory air filter.
My question is why does my engine only run with the air/Fuel screw all the way in?
What can I do to run the open style air filter?
Thanks

Pages: [1]