1
Agility 50 / Re: miles on your agilty
« on: November 16, 2012, 03:40:18 PM »
19,600 km on my 09 agility
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Agility 50 / Re: 100 octane gas
« on: September 12, 2012, 02:12:38 PM »
I will try half of a gallon of 100 octane today and see if I get any results. thanks
3
Agility 50 / 100 octane gas
« on: September 11, 2012, 01:31:17 AM »
Does anyone have any experience running 100 octane gas every now and then?
There is a station that has it for sale as racing fuel. I'm wondering if I can run a tankful every now and then and do away with the seafoam.
Would that octane be too much for the engine?
There is a station that has it for sale as racing fuel. I'm wondering if I can run a tankful every now and then and do away with the seafoam.
Would that octane be too much for the engine?
4
Agility 50 / Re: Agility 50 feels sluggish
« on: September 04, 2012, 12:41:19 AM »
Is Redex any better than seafoam?
5
Agility 50 / Re: Changed my rollers, now a problem
« on: August 18, 2012, 04:43:13 PM »
Here are the previous rollers, they were in bad shape.
6
Agility 50 / Re: Changed my rollers, now a problem. I fixed it
« on: August 18, 2012, 04:40:30 PM »
I had put the sliders in wrong. It looks like they were upside down.
I took the scoot for a 2 mile spin and it ran great.
Very good accelleration from the start. Nice and smooth.
It looks like I did lose the expected 2 miles per hour or so top end.
Now on to find a shop that will mount my new rear tire for me.
Thanks for the help.
I took the scoot for a 2 mile spin and it ran great.
Very good accelleration from the start. Nice and smooth.
It looks like I did lose the expected 2 miles per hour or so top end.
Now on to find a shop that will mount my new rear tire for me.
Thanks for the help.
7
Agility 50 / Re: Changed my rollers, now a problem
« on: August 18, 2012, 12:02:29 AM »
I forgot to add that I bought sliders, not rollers.
Does that change anything?
Does that change anything?
8
Agility 50 / Changed my rollers, now a problem
« on: August 17, 2012, 11:07:09 PM »
I changed the rollers on my agility 50 (derestricted)
I was able to cruise along at 42- 45 mph (speedo) prior to the change.
The old rollers were getting pretty worn with a lot of low spots.
Now that I have changed the rollers to 5.5grams, The takeoff is quick and good but when the scooter gets up to about 35mph, it struggles, the rpms sound like they are whining and the valves start to tap if I go close to 40.
Do I have to adjust the valves when You change rollers?
I'm also thinking maybe I have the rollers in wrong.
I am thinking of trying both things tomorrow.
The scoot was running great before I fixed it.
Any thoughts? thanks
I was able to cruise along at 42- 45 mph (speedo) prior to the change.
The old rollers were getting pretty worn with a lot of low spots.
Now that I have changed the rollers to 5.5grams, The takeoff is quick and good but when the scooter gets up to about 35mph, it struggles, the rpms sound like they are whining and the valves start to tap if I go close to 40.
Do I have to adjust the valves when You change rollers?
I'm also thinking maybe I have the rollers in wrong.
I am thinking of trying both things tomorrow.
The scoot was running great before I fixed it.
Any thoughts? thanks
9
Agility 50 / Re: A little help
« on: March 30, 2012, 12:39:28 AM »
Thanks Blue. I live in North Carolina so, I was able to ride in the winter. The coldest that I rode in was 25 degrees so it wasn't too bad.
I think I have cleaned the jets about every 6 to 8 weeks. I don't know if that is normal or not.
But the scoot does appear to run better with the seafoam added every 2 weeks or so.
I think I have cleaned the jets about every 6 to 8 weeks. I don't know if that is normal or not.
But the scoot does appear to run better with the seafoam added every 2 weeks or so.
10
Agility 50 / Re: A little help
« on: March 30, 2012, 12:36:51 AM »
Thanks Streido
I will try to figure out a way to check the boss. I have been wanting to change the belt, just in case.
Today I checked the plug and it was fine. I turned up the idle just a bit and it seemed to run back to normal. I was getting 7 kmh without wide open throttle(close though).
I will try to figure out a way to check the boss. I have been wanting to change the belt, just in case.
Today I checked the plug and it was fine. I turned up the idle just a bit and it seemed to run back to normal. I was getting 7 kmh without wide open throttle(close though).
11
Agility 50 / A little help
« on: March 29, 2012, 02:28:05 PM »
Hey
Newbie to posting but, was a lurker for a little while. I've learned a lot form the board.
Now, I have a 09 agility 50, It has the derestricted cdi and the boss has been added. These changes were done before I bought the bike. It has 17k on it .
The bike has been running well with no problems , except the need to clean the jets every now and then.
2 weeks ago, I went to clean the jets and noticed that the main jet is still a 80. My scooter shop only had an 85 and did not fit when I tried to change it.
Now the bike is running poorly when cold, it only goes about 50kmh. Previously it was going up to 70 and 75 down hill.
When the bike warms up real well , the top speed it back to about 65 kmh.
I'm unsure if it is running lean. I never had any sxs before, the spark plug was clean when I pulled it. Why would it run lean now?
Is there anything else that I can do until I change the jet? Where can I order the correct jet? I'm pulling the plug today to check it. Thanks a lot.
I'
Newbie to posting but, was a lurker for a little while. I've learned a lot form the board.
Now, I have a 09 agility 50, It has the derestricted cdi and the boss has been added. These changes were done before I bought the bike. It has 17k on it .
The bike has been running well with no problems , except the need to clean the jets every now and then.
2 weeks ago, I went to clean the jets and noticed that the main jet is still a 80. My scooter shop only had an 85 and did not fit when I tried to change it.
Now the bike is running poorly when cold, it only goes about 50kmh. Previously it was going up to 70 and 75 down hill.
When the bike warms up real well , the top speed it back to about 65 kmh.
I'm unsure if it is running lean. I never had any sxs before, the spark plug was clean when I pulled it. Why would it run lean now?
Is there anything else that I can do until I change the jet? Where can I order the correct jet? I'm pulling the plug today to check it. Thanks a lot.
I'
Pages: [1]