Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnwc91091

Pages: [1]
1
zx50 / Re: Help me get started (pun not intended)
« on: February 27, 2012, 05:44:50 PM »
No, I did not clean out the tank, where is this filter located?
Could you clarify on vacuum line/fuel line process?

2
zx50 / Help me get started (pun not intended)
« on: February 27, 2012, 07:20:02 AM »
Hello everyone,

I've got an '05 Filly 50 LX (which I learned is the identical cousin of a ZX50 thanks to zombie!) that won't start after a few years of *sniff* neglect.

I recently:
Replaced fuel, spark plug, battery, 7amp fuses
Cleaned out the carb, fuel filter
...but it still won't start!!

Some observations:
- Headlight and taillight doesn't turn on, but brake lights work when pressed upon.
- Electric starting system seems to work, spark plug is giving off a decent spark like it's supposed to.
- Spark plug is dry after a few attempts to start it.
- Little fuel comes out when the drain screw is removed (after quite a bit of throttle during attempts to start).

Any clues to help me get started? I'm a full time college student neck deep in exams, projects, relationship problems and etc...so I can only work on this bike ever so often. I'll try update my progress (good or bad) as I get my hands on this lil Filly.

I'm also new to working on scooters, so it would be nice if y'all can dumb down the technical vocabulary for me.

Much appreciated!

3
Technical | How To / Re: Kymco Filly 50 LX
« on: February 17, 2012, 11:20:12 PM »
Thanks zombie!

4
Technical | How To / Kymco Filly 50 LX
« on: February 17, 2012, 10:33:58 AM »
Hi everyone,

Just wondering if anyone is familiar with the wiring setup of a 2005 Filly 50 LX.
There's a green&yellow wire that was disconnected near the vicinity of the tail light when took off the MET-IN box. I'm not sure if it is supposed to be connected or not, any insight would be appreciated!

Pages: [1]