Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jesionowski

Pages: [1] 2 3
1
Agility 125 / Re: 3 years of sitting - Need carburetor part number
« on: July 20, 2018, 12:02:05 PM »
Put in a new carb yesterday. and new CDI last year. Will run on starting fluid but feel like it isnt getting gas. $40 for the auto cock. But I think that is working. Cause when the engine is turning over the autocock opens and fuel flows. Running out of ideas.

2
Agility 125 / Re: 3 years of sitting - Need carburetor part number
« on: May 30, 2017, 12:26:38 PM »
Quote from: Mr. Paul on March 16, 2017, 09:42:48 PM
I would recommend you try to clean the carb yourself. Its not really that difficult and there are a lot of instructional videos. Just look up gy6 carberator cleaning.  If however you would rather purchase the carb the number is 1610K-LDF7-M30. Its about a hundred bucks at Kymco Parts Monster. I would really try to clean it first though.

The one I see at the site is about $30, although I have seen them for around $100. I replaced the CDI and plug and the scooter definitely has spark but does not stay engage, gummed up carb after sitting for three years. I did and oil change and replaced the gas. Put seafoam in the new gas but will only run for about 5 seconds.  Thinking of getting that $39 carb from monster parts. I figure If I am going to pull it off to clean might as well put a new one on.

Any good videos on doing this??

3
Agility 125 / 3 years of sitting - Need carburetor part number
« on: March 16, 2017, 02:59:26 PM »
My 2009 Agility 125 has not  run in three years. Going to attempt to restart it this Spring.  New Battery, New Gas New Spark plug, New Fuel filter, New Carburetor.

Does anybody know the part number of the carburetor? If its around $30 might be easier to replace rather than clean.

Also is YTX-7A -BS  the correct battery. I cant find my original one, took it out last year and lost it.

4
Agility 125 / Re: Agility 125 turns over, but no spark...
« on: October 12, 2015, 07:24:28 PM »
sounds like my issue, where did you buy the cdi

5
Agility 125 / Re: cdi unit
« on: June 30, 2014, 12:44:59 PM »
Please let us know the out come of this. My bike which just ran several days before wont start and I am not sure what to replace/check first. Its six years old so the CDI could be suspect.

6
Agility 125 / ID of gas line for shut off valve
« on: September 14, 2013, 11:53:32 PM »
Has anybody installed a shut off valve on the gas line for winter storage? and if so what size ID is the gas line. I want to run the carb dry this winter before storage.

7
Agility 125 / Re: Tire change
« on: September 06, 2013, 03:04:44 AM »
no tube

8
Agility 125 / Tire change
« on: July 13, 2013, 11:57:46 PM »
Here are some pics of my weeekends tire change.

My advice. Just do it. Its way easier then it looks. The only thing is I took the tire to a shop to have the tire put on. I tried putting the front wheel back on the rim myself and ended up damaging the tire, Had to buy a new one. But it cost $60 to mount a tire if its on the bike and $25 if you bring in the tire off the bike. So I ended up still slightly ahead money wise.

I got Michilen City Grips. So far they feel pretty good. Not a dramatic change but I am hoping for better rain riding.

I repainted the muffler with Engine heat paint. Right where the muffler comes off the engine the paint burnt off but still looks fine on the main body of the muffler.




















9
Agility 125 / Re: Changed Tires!
« on: March 11, 2013, 01:48:30 AM »

Did you take any pics. I need to do this in a week or two.

10
Agility 125 / Re: New Tires - Focus On Wet Traction
« on: May 22, 2012, 01:27:18 AM »
OK, City grips it is. Based on this thread. I have 7k on the OEM and could probably go at least one more year but I really want to ride into November, so I need a better rain tire. I am going to try to replace them myself.

11
Agility 125 / Re: How to change tires...video???
« on: May 17, 2012, 02:29:15 AM »
So if I get the tires off the local repair shop will do it for around $25 each.  From experience with changing many bicycle tires I know the smaller the harder it is.  Thanks for the post it was just what I was looking for.

12
Agility 125 / Re: Mirror extender
« on: May 07, 2012, 12:04:37 AM »
Quote from: Vivo on May 03, 2012, 03:34:30 AM
Paint it flat black now!!!



OK, its black and I finshed the other one. Did a test ride with the new set up. Wow. I wish I did this three years ago.




13
Agility 125 / Mirror extender
« on: May 03, 2012, 01:08:13 AM »



As we all know the OEM mirror gives a realy nice view of your shoulders. The extenders for sale only kick the mirrors out about 2 inches.  So I made my own. They seam very solid so I am not anticipating any fatigue issue. The components are aluminum and a stainless steel bolt, and locking nut. $3 for the fasteners and about $3 for the aluminum bar. So $6 for two or $3 a piece.  If you are going to try making these...ebay for the material, and the bolt is M8 x 1.25, ACE hardware. I will eventually paint then black.

14
Agility 125 / How to change tires...video???
« on: May 01, 2012, 05:36:53 PM »
I have 7800km on the OEM tires. Still plenty of thread but want new ones for better riding in the rain. Several of the local shops wont touch a scooter and the ones that do want $60 labor per tire.

The back looks easy but what about the front. I tried looking for some good how to videos. Can anybody point me in the right direction or offer advice.

Also I am looking at Michilin City Grips. Traction isthe only thing I care about.

15
Agility 125 / Re: Who has the most Kilometers (miles)
« on: August 11, 2011, 05:20:04 PM »
7555km, Just a cracked side panel...not due to a drop and not cover by warranty. 2008 model.


Pages: [1] 2 3