Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - szro

Pages: [1]
1
People 50 / Re: How to tell the year of a People 50?
« on: April 23, 2012, 08:11:05 PM »
Hi!

There is a VIN Decoder for Kymcos. The VIN is behind the lid leg shield.

2
People 50 / Re: How to derestict the people 50 2 stroke
« on: April 22, 2012, 10:13:57 PM »
Why is that small spur on my exhaust, is it a restriction?

3
People 50 / Re: How to derestict the people 50 2 stroke
« on: April 22, 2012, 10:12:49 PM »
This is my CDI.

Is my CDI restricted and could be derestricted or I must it replace?

4
People 50 / Re: How to derestict the people 50 2 stroke
« on: April 22, 2012, 10:11:30 PM »
Hi all!

I purchased a second hand scoot a few weeks ago. The scoot was made in 2002. I checked some parts of it and I suppose it is restricted yet. I took some photos about CDI, exhaust and boss driver.

To check the boss driver I tried to remove the outer pully half, but I couldn't remove the nut. I used rust remover spray to facilitate my work.
I streched the pinion, but failed to loosen the nut. I think I'm a guy with good power so I won't break or bend something. Can you give some good ideas how to do it without damage?


Here are the photos:

5
People 50 / Re: How to derestict the people 50 2 stroke
« on: April 20, 2012, 07:32:01 AM »
thank you for your answer.  :)

6
People 50 / Re: How to derestict the people 50 2 stroke
« on: April 19, 2012, 08:41:44 PM »
Hi all!

If I want to derestrict the boss drive in my scooter must I replace the restricted bushing or can I lathe it.

7
People 50 / Re: Air Filter and stuff
« on: April 19, 2012, 08:17:42 PM »
Hi!

I'm new on this forum.  I Purchased a People 50 T2. I checked the air filter, and I saw that's a sponge. How thick should be the foam, the current is 15 mm (0.6 inch).

Thank you in advance for answers.

Pages: [1]