Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kidbuffalo

Pages: [1]
1
People GT 300i / Biondi windshield & Dr. pulley sliders results
« on: July 31, 2013, 01:12:08 AM »
Well I have the new Biondi windshield on and so far I think its great. A lot less wind noise and a pleasure to ride. I'm 5'10" and I can see right over the top with no problem.  As far as the Dr. pulley 14 gr sliders, I expected a little better performance.  The 0 to 50 MPH is a little quicker, but the 50 to 70 is not what it was before. I thought I didn't put them in correctly, so I took it apart again to check, installed like they're supposed to be.  So since I don't usually go much over 60 mph, I guess they'll stay in. Good riding guys....

2
People GT 300i / Re: Small exhaust cover coming loose.
« on: July 16, 2013, 12:44:05 AM »
Hey scootgrl, Wish I paid attention when I read this last year. I was getting a buzzing noise when taking off and after a little looking, I found out one of my screws came out also. Got a replacement at home depot and this time I put locktite on them. Pay attention to the lady guys....

3
People GT 300i / Windshield ???
« on: June 18, 2013, 01:10:20 PM »
I'm looking into buying a windshield for my GT. I hear how much better it is riding with one. But I need some input on which one to get. I hear a lot of good things about Biondi and only a few negative things ( like a little blurry when things are up close around turns ). Isn't there one from KYMCO out there ?

4
People GT 300i / Re: top box rattle fix
« on: May 23, 2013, 12:53:07 AM »
Hey Boo, Here's a permanent fix that I did. That tape well get sticky in the heat. Pull the pins out and find something like a straw ( I used a piece of shrink tubing ) that well slide onto the pin. Put a little silicone grease on the pin so it can slide in the tubing. I then put a little gorilla glue on the tubing and push it into the hinge part of the top. While the top is off. Let it harden overnight and pull the pin out, trim off the excess tubing and now there's no slop in the hinge. Hope I explained it well enough .

5
People GT 300i / Sliders ??
« on: May 02, 2013, 09:24:44 PM »
I hear all this talk about sliders. If I want a little more acceleration on my People GT 300. How do I find out the right size and weight ? Some where I read , put in Dr. Pulley 20 x12 -14 Gram sliders. Any help here .......

6
People GT 300i / wish my people gti300 had a radio
« on: August 30, 2012, 09:27:07 PM »
 >:( I see other scooters out there that have radios. I don't think the kymco could handle the power it would require though. Unless someone did add one already. Anyone know if it could be done ?

7
People GT 300i / Re: Manual
« on: August 20, 2012, 12:48:11 AM »
Quote from: ScootrGrl on April 15, 2012, 09:00:09 PM
Where can I get my hands on the repair/shop manual for the 300?  I've been looking all over and I'm not sure if some of the sites I find are reputable.

Thanks!

Tracy
My dealer e-mailed me the PDF file. Don't  know why yours can't

8
People GT 300i / Just where is the crank case vent tube that is supposed to be cleaned .
« on: August 19, 2012, 02:51:16 PM »
On my People GTi 300 it mentions to clean out the crankcase vent tube every so often. Just where the heck is it anyways ? :(

Pages: [1]