Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Superstu

Pages: [1] 2
1
Super 9 / Re: Super 9 Ac engine to Lc engine
« on: August 21, 2013, 03:27:10 AM »
I've looked at both wire diagrams. The only difference I can fine is the lc has a tack and a temp light in the dash. From what I can see the wires off the lc stator are the same as the ac stator. It should have all the same electronics and the plugs are the same. Looks like it will plug right in.

2
Super 9 / Re: Super 9 Ac engine to Lc engine
« on: August 05, 2013, 02:13:09 AM »
Well that could be a problem. I payed 150 for it. Its a rolling frame with motor with compression, radiator and hoses. But no wire harness. The only wires are the ones off the stator and starter. I thought i could use my wire harness with some modification?  Do you think i payed to much and am i in trouble witb this before i get started?

Thanks for your info and help batman

3
Super 9 / Re: Super 9 Ac engine to Lc engine
« on: July 30, 2013, 03:15:50 AM »
I looked through all 13 pages. I didnt see anything about the wiring differences between the 2 bikes. But during this swap i will need all the help i can get.

Thanks stu


4
Super 9 / Super 9 Ac engine to Lc engine
« on: July 26, 2013, 02:47:32 AM »
I have a 07 ac super 9 I also have a 04 lc motor. Also all the parts to make the lc motor to work. My questions are will the 04 motor fit my 07 also are the electronics the samew on both bikes?

All the help would be appreciated there's not a lot of info on this conversion.

5
Super 9 / Modifying stock super 9 carb
« on: March 31, 2013, 10:50:20 PM »
I have an AC super 9 with a 70cc kit. But I'm trying to tune the carb and I noticed there is no notches on the neddle valve. Is there any way to fix this problem? Maybe put a different neddle in it or maybe get a neddle with notches and swap it. S help my cht is running a little hot.

Thanks stu

6
Super 9 / Re: Mysterious raspy/buzz sound Help
« on: January 31, 2013, 05:39:24 PM »
How did u adjust your neddle on the stock s9 carb? I've had it apart a few times and it looks like it none adjustable.

Thanks
stu

7
Super 9 / Re: damn idle
« on: January 29, 2013, 08:37:19 PM »
On super 9 which way riches up the a/f screw? I've seen a few condescending post.
I just want to know from a kymco owner.

stu


8
Super 9 / Re: Mysterious raspy/buzz sound Help
« on: January 24, 2013, 02:42:14 PM »
I don't think it's the plastics bc I have most removed. Do you hink I need a 19 or 21 carb for the 70cc? Like I said it buzzes when I'm barely on the throttle. When I give it more it goes away. Do u think I need to up my pilot jet? I did drill it out. Also in the stock carb I can't adjust the needle. I tryed to use a small washer but it will not lock in could that be causing it to be rapper out the exhaust.

It just scares me that it blowing up. I soft seized the last kit.

Thanks
stu

9
Super 9 / Re: Mysterious raspy/buzz sound Help
« on: January 22, 2013, 05:37:05 PM »
I have an AC with malossi 70cc kit with 10000km. The noise happen when I'm cruising at 40 turning like 7500 8000rpm. Just when I get on the throttle about 1/4 when more throttle is applied it goes away. I check the drive line and it looks pretty good.

Stu

10
Super 9 / Mysterious raspy/buzz sound Help
« on: January 20, 2013, 03:20:31 PM »
I have been having a buzzing noise when I'm up to speed and 1/4 throttle. It seems to go away with more throttle. I thought it was my reeds so I got new ones ans installed them. Still same noise. I pretty sure it's not the exhaust all the bolts are tight. I thought it might be ping or detonation problem. Plz help I'm scared to ride because the raspy buzz sounds bad. It just seems like it happen at the top end of mph at low speeds I'm good.

Thanks
Stu

11
Super 9 / Re: Best plug for s9
« on: December 31, 2012, 02:07:21 PM »
I just don't want to burn a hole in my piston again. I thought the iridum was one of the reasons I melted it.

12
Super 9 / Best plug for s9
« on: December 30, 2012, 10:49:29 PM »
Just wanted to see what plug ppl run in there super 9? Does the hix burn hotter then like brs7hs? I or if the heat range is 7 on both plug its the same. I just don't want to put iridum plug in and melt my piston.

Thanks
stu

13
Super 9 / Re: Where to buy super9 AC reeds...
« on: December 21, 2012, 12:07:55 AM »
I will have to look. I bought the scoot a few months ago. It has a few aftermarket parts bbk exhaust ect. To Derestrict the pulley do you have to buy a new one?

14
Super 9 / Re: Where to buy super9 AC reeds...
« on: December 19, 2012, 05:28:14 PM »
Yes it has the restricted boss out. I with I could have got the LC.

15
Super 9 / Re: Where to buy super9 AC reeds...
« on: December 19, 2012, 02:48:45 AM »
Wow 65 do you have upgraded gears? I only get to 50 and it's revin so high I let off.

Pages: [1] 2