KymcoForum.com

tx 4 the post about the turn signal work around.  i  know that post is old (by kryden), but i hope someone helpful will see this.  i can also be reached at stanleystankas@yahoo.com  i have the 125 and the signals work fine but being clumsy around my scoot as well as an ill fated attempt at a theft i have broken off the signal housing under the seat box and replaced that entirely and also keep gluing back together a rear signal cup on the left side due to a bad guy trying to steal my scoot and not realizing i had a u lock on the back wheel so in spite he knocked it down.  i am looking at something more flexible and while in a scoot shop i noticed a genuine scoot w/ some nice led rear signals that were more rubberized and gave a bit when contacted.  that is really what i would like to swap out my signals w/ at least the rear because i tend to knee them.  i am not very technically orientated obviously, but i do have the service manual on the scoot and w/ patience i would like to swap this out myself.  thoughts on what might accomplish this situation?  it appears kryden left the original signals in place 4 markers which might also be a possibility, however do not know if i can accomplish what he did. tx