Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - phaedrus62003

Pages: [1]
1
zx50 / Re: Kymco gears
« on: February 24, 2016, 09:26:04 PM »
I found a Malossi set 16/32 primary on this site including installation pictures. I did the swap myself with a homemade bottle jack press. The Malossi set is available from Racing Planet and probably many others in Europe. The gears are supposed to be 15% taller than stock. I am looking for dyno results from the Fabrizi 80cc cylinder; your horsepower figures for Polini and Malossi are informative.

2
zx50 / Re: Flotek ported and built 82cc Fabrizi/MHR SC10AS
« on: April 10, 2015, 08:45:18 PM »
Hi, I was wondering when road tests and/or dyno test results might be available. The stock intake manifold looks restrictive and the intake windows as well. I am using an Airsal  70cc cylinder,  Arreche 19mm carburetor, and Tecnogas expansion pipe. Also installed Malossi upgear kit. My goal is to get to a solid 50 mph on flat ground. Being around 225 pounds is a major factor against this. Currently using an Asian variator and 7gram weights. Adding a top racing reed valve kit today. The aging Honda clone probably won't see a Direct Injection conversion, but its the only hope for 2 strokes.

Pages: [1]