Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SydScoot

Pages: [1]
1
Venox 250 / Venox 250 Stalling issues
« on: August 18, 2013, 01:49:00 AM »
I had a similar problem on my Kymco scooter. Would stall out, and not restart for a few minutes. Never seemed to be a consistent set of factors. Turned out to be the CDI. got a new one and hasn't happened since. I understand Kymco had some problems with faulty CDI's.
 Not a 100% sure it would apply to your model, but might be a possibility?

2
People 150 / Crankcase cover and how do I remove it
« on: June 23, 2013, 09:19:57 AM »
Hi all. Well I finally got round to this. Got the CVT cover off buy kicking on the kickstarter and rubber mallet-ting the other end for about 5 mins. Eventually came off. Took a lot of bashing to get there though. The rubber gasket was holding it on but came off undamaged. Changed roller weights and belt, scooter running much smoother now.

3
People 150 / Crankcase cover and how do I remove it
« on: June 18, 2013, 09:09:25 AM »
Well I'm going to have a try again his weekend, so will try removing the kickstarter and see it that helps. Will let you know! Thanks for your replies!

4
People 150 / Re: Crankcase cover and how do I remove it
« on: June 16, 2013, 09:05:37 PM »
Hi Calothrix,
 No, didn't remove kick starter lever, but as poster above said you don't need to on a People 150.
 Service manual also shows this is the case.

5
People 150 / Crankcase cover and how do I remove it
« on: June 15, 2013, 11:57:10 PM »
Hi, just had the same problem with my 150, tried the rubber mallet but still wouldn't budge. Wonder if the OP had any success?

Pages: [1]