Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 2010iron883n

Pages: [1]
1
Agility 125 / Re: I need a little info if someone can help . I need to know about some bolts
« on: June 02, 2013, 03:51:30 PM »
Sorry , I am late getting back. its funny I went to advance yesterday and got two header gaskets and made me some washer. As soon as my collars come I  can put it back on. I am worried to death about the vibration I am feeling that comes and goes. its kinda a fluttering vibration, I need a tire, this thing sat for 2 yrs when I screwed up the drive plate on the crank. The vibration was there then. I am wandering if the wallering variator and screwed up my belt face. my scooter has 17000 k , never replaced the belt , but it don't look that bad. you can tell its been used but not cracked all to pieces

2
Agility 125 / Re: Changing the final gears 2013 agility 125
« on: June 02, 2013, 03:02:38 PM »
Everyone told me that the agility was diff from a gy6, but I just had my crank replaced and all the seals , gaskets, rings, and oil pump. The guy that done it says the engine is identical. I am having a vibration that comes and goes but my Tranny , (final Drive) isn't making any noise. I have notice my belt is looking a little ruff. its almost a fluttering vibration. I hope my tranny doesn't have a bad bearing, but you would think itd make noise. What do you guys think?

3
Agility 125 / Re: Agility 125 spark plug
« on: May 24, 2013, 11:10:30 AM »
if the up and down idle is only when its cold, then its normal.

4
Agility 125 / Re: Help me out here guys, my agility 125 is clattering on the right side
« on: May 24, 2013, 11:08:18 AM »
can the cam chain guide come loose, then the chain would smack the tensioner? is this a possible problem that could happen. .

5
Agility 125 / Help me out here guys, my agility 125 is clattering on the right side
« on: May 23, 2013, 09:10:39 PM »
just had a new crank , piston rings, and seals put in my 2007 agility 125. Mechanic said it looked like new inside. Anyhow i rode it a little today and it started clattering on the right side. i think it is the magneto. Can a magneto make that kinda noise? this engine was just completely disassembled. I dont have a puller to take it off is the only problem. Now i guess ill have to haul it an hr to get it checked. im praying it is the magneto. it runs like it did the day i bought it brand new. The crank was fine till i screwed it up the first time i messed with it, had no idea to take the tension off the belt.

Pages: [1]