Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nomadrac

Pages: [1]
1
General Discussion / Re: What's your favorite scooter modification for $150 or less?
« on: December 07, 2013, 03:31:29 AM »
Changed my boss pulley, and rewired my cdi, got another 15mph.  Also bought some red reflective tape off of ebay and applied it to my scooter for extra safety

2
General Discussion / Re: What's your favorite scooter modification for $150 or less?
« on: December 07, 2013, 03:25:42 AM »
you may replace, or rewire the cdi, my mooed gained 15 mph

3
zx50 / Re: ZX50 Super Fever won't start. Please help me!
« on: December 05, 2013, 02:44:14 AM »
Quote from: danovr on December 01, 2013, 05:01:37 PM
Finally got it going now :D
Thanks for all your help.
It was actuallu the reed valve that didn't close properly.
. How did you figure the reed valve wasn't functioning correctly?

4
Technical | How To / Re: CDI issues on a 2005 zx50 Super Fever
« on: November 24, 2013, 02:17:26 AM »
the CDI is AC power ed

5
zx50 / Re: ZX50 Super Fever won't start. Please help me!
« on: November 23, 2013, 04:56:01 PM »
If you don't have a service manual, Google for it and go thru the troubleshooting in Ch. 15 for your electrical system. check resistance values against service manual specs. maybe you have a week spark, or bad CDI,  the CDI is powered by AC voltage, check generator too

6
zx50 / license plate light replacement tip
« on: November 22, 2013, 05:42:13 AM »
I recently replaced my license plate light with this 5 led, long lasting replacement bulb. http://www.amazon.com/gp/product/B009IEQE86/ref=cfb_at_prodpg
This is a T10 bulb replacement, works on other models of Kymco scooters

7
zx50 / Re: Original zx blinkers
« on: November 22, 2013, 05:37:08 AM »
wish someone would try this, to meet it looks like the front cover amber lights have no bulbs in them

8
zx50 / Re: CDI issues on 2005 zx50 Super fever
« on: November 17, 2013, 07:09:11 PM »



look at chapter 15-7 in the service manual, ( Google for link to PDF file)
wiring diagram shows AC generator is connected to the CDI

9
zx50 / Re: seat latch not engaging -FIXED
« on: November 16, 2013, 11:08:13 PM »
By taking off the seat and repositioning things slightly, the seat now latches closed.  It wasn't going down far enough into the latch for the seat 'bar' to engage. Thanks for your help

10
zx50 / Re: seat latch not engaging
« on: November 16, 2013, 10:24:33 PM »

11
zx50 / Re: exhaust washer
« on: November 16, 2013, 10:22:13 PM »
Thanks

12
zx50 / Re: seat latch not engaging
« on: November 16, 2013, 10:21:12 PM »
I have oiled the latch, still doesn't work, please see photos...is there anything like a cable connecting the key lock to the latch? Thanks in advance

13
zx50 / Re: exhaust washer
« on: November 15, 2013, 09:48:19 PM »
Quote from: naughty lee on November 01, 2013, 09:31:02 AM
A vice, a hammer and a small chisel

is the washer on the exhaust inlet or outlet side

14
zx50 / seat latch not engaging -FIXED
« on: November 15, 2013, 09:45:59 PM »
[/]
Hi ,  I can't get the seat latch to lock the seat down.   Any suggestions? I bought this zx a few weeks ago, it is clean, very low miles and the only problem with it is that I can't lock the seat/storage bin.

15
zx50 / exhaust washer question ANSWERED
« on: October 31, 2013, 02:40:32 PM »

Hello, I have an easy question. How do you remove the exhaust washer?
I am looking at buying a 2005 ZX50 with 626 miles on it for $700

Pages: [1]