Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 50ccAgility

Pages: [1]
1
Agility 50 / Engine not running right after rebuild
« on: March 31, 2014, 07:39:58 PM »
Hi folks, i previously fitted a new piston, head, valve springs and gaskets to my Agility City 50 engine. I got the bike started today and have good healthy compression and the engine is ticking over well. When on the stand it will rev nicely and the wheel turns well in comparrison to how much throttle im using. However, i spent a bit of time just going very slow and gentle to run the engine in. Now that i feel its ready to give full throttle, the bike wont pull away as well as it should. The engine is reving but the bike is struggling to go over a walking pace. iv got a feeling its a carb related problem. Does anyone have any comments on this or suggestions on how to do some adjustments to make the bike run the way it should? Its only pulling on the first inch of play in the throttle. Hills are a no go!
Look forward to seeing what ideas people have!


Cheers

2
Agility 50 / Re: URGENT!! Bike wont start after new head and piston
« on: March 13, 2014, 01:16:17 PM »
Yeah its full every time, however the plug never seems to be wet when i take it out after tying to stsry it. Wonderig kf it something to do with the wire tht goes from the carb, possibly  automatic choke?

3
Agility 50 / Re: URGENT!! Bike wont start after new head and piston
« on: March 13, 2014, 07:43:47 AM »
Hi Karl,

Thanks for that, however once i set the timeing the bike still wont fire up. It has good compression, spark and fuel flow but it doesnt seem to want to fire up. Any input on this? What could iit be? Its turning over fast but wont start

ally

4
Agility 50 / URGENT!! Bike wont start after new head and piston
« on: March 11, 2014, 10:13:13 PM »
Hi folks,

I have had a lot of bother with my Kymco Agility City 50, its always breaking down, however after a bit of time it will run again! Strange! I broke down the other day and lost compression on the bike
 I decided to strip the engine, the piston and rings were knackered and so was the gasket and the head. Got a kit and replaced all parts. I went to start the bike up and ITS GETTING FUEL AND A HEALTHY SPARK. He bike will turn over but will not fire up. Does anyone have any suggestions? Could the timeine be the problem? Does anyone knlw the markings for setting the crank? I found some brid instructions and lined it all up but doesnt seem t go! help please!!

Ally

Pages: [1]