Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Shooting Jack

Pages: [1]
1
General Discussion / Re: wiring schematic for 05 mxu 150
« on: June 26, 2014, 03:28:51 PM »
You da Man. The spring in the brake light switch is weak and will not go out all the way to allow the 150 to start. Not sure if you were talking about replacing the switch with a relay. After rereading your post I got it. I will check on a brake light switch. Hope it's not that expensive. LOL Thanks again.

2
General Discussion / wiring schematic for 05 mxu 150
« on: June 23, 2014, 06:03:46 PM »
I recently purchased this unit and had replaced battery and fuse and was cranking as it should. Today I went outside to ride it and it would not crank. Panel lights up but no response from starter button. One wire at solenoid is ground but when starter button is depressed it appears that the other wire is grounded also but only when button is depressed. It does not appear to have any voltage at the starter switch. It was in a small shower last night but all appears to be dry.

Pages: [1]