Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ronnie

Pages: [1]
1
Downtown 300 / Re: Hesitation during hard aceleration
« on: December 31, 2014, 10:43:59 PM »
Quote from: windwheeler on December 31, 2014, 02:01:47 AM
You were just plain lucky if you changed it 180 degrees counter-clockwise and it worked. When I went to 180 degrees mine stalled constantly and didn't start properly after it had warmed up.

Usually there is a sweet spot that one needs to find by moving the MAP sensor in either direction in small increments. Then test ride the scooter and see it it got better or worse, and find the best position. It's usually trial and error until one gets the best result.

My DT has stalled after a warm start I just give it a little throttle when starting and its OK and doesn't stall during operation.

2
Downtown 300 / Re: Hesitation during hard aceleration
« on: December 31, 2014, 01:27:15 AM »
I have a  2013 DT with the same hesitation, easy fix is on the throttle body is the map sensor loosen screw and turn it 180 degrees left
lock it in place tighten screw be careful not to loose O ring.

Pages: [1]