Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jetmech7065

Pages: [1]
1
MXU / Re: 08 MXU 150 dies when put in drive or reverse
« on: February 03, 2015, 03:40:23 AM »
I can get it running with using the kick starter. As the battery was to low and would no longer hold a charge. That's why I replaced the battery. But when it is running like I said it dies as soon as it's put in gear. And this one does have to have the brake lever pulled. When it's not running but the key is in the on position and I move the shift lever from Nuteral to fwd or Rev I can hear the solenoid make a click noise when I move the shifter

2
MXU / Re: 08 MXU 150 dies when put in drive or reverse
« on: February 02, 2015, 10:12:16 PM »
zombie I pulled off the CVT cover and all looks gook other than I have a chipped tooth on the kickstart spline. The clutch free spins and and when I move the selector into gear (motor not running) and move the clutch it turns the wheels. I'm thinking I have an electrical grimlen as I just put a new battery and I get nothing when I hit the start switch and my gage cluster lights up but I can't find any blown fuses or ground out wires any thoughts ?

3
MXU / Re: 08 MXU 150 dies when put in drive or reverse
« on: January 21, 2015, 10:51:55 PM »
@ Zombie  thanks for the fast reply😀 I tried that still a no go. I can rev the motor as normal but as soon as I put the gear selector in Fwd or Rev it dies as if the kill switch was pushed.

4
MXU / 08 MXU 150 dies when put in drive or reverse
« on: January 18, 2015, 12:54:50 AM »
Hi new to the forum here. I have a 2008 MXU 150 that just stoped working over night. When I start it and go to put it in fwd or rev gear it dies right away. As if you arn't pulling in the clutch lever on the right handlebar even tho it's an automatic. Any sugestions would be appreciated.

Pages: [1]