Fault codes 2 and 7. Air pressure sensor and crankshaft position sensor

[Roads by TJ]

I am recently receiving the fault codes 2 and 7. I am mechanically inclined and want to fix this myself and having said that I can't find them on the bike or to purchase. Any ideas or pointers for me?
2016 like 200i 2,100 miles.

[Stig / Major Tom]

How is the scooter running?
If running fine, do you know the reset procedure and  have you done a reset?

Stig

[big blue]

Here is the reset procedure, ignore step 3.

[Roads by TJ]

The scooter is running OK and doesn't seem to have any trouble running but I also have a battery charging issue so I'll need to grab a multimeter and test the system. I'll check the connections for the two codes as well. That's where I'm at right now.
TJ

[Roads by TJ]

Thanks big blue for the steps to reset my codes much appreciated.
TJ

[Roads by TJ]

Here's an update. I changed out a bad regulator and cleared the codes and it seems to run normal. I'm thinking that when the regulator went out it tripped the codes. Running a few couple days now with no new codes.
However, now I have found a new issue. When sitting at idle if I twist the throttle just a little it will ct like it's going to stall out but back off or a tad more twist and it's fine. No problems while driving either. Any guess on this? My thought was the twist throttle itself might be doing it.
What do you think?

[MstExplr]

Perhaps your TPS (throttle position sensor) needs to be reset.

1) Kill Switch to run.  2) Key to off. 3) Open throttle. 4) Key to on. 5) Wait 8 seconds. 6) Key to off. 7) Key to on.

Start it again and see if that worked.