Changing rotors to my downtown 350

[Yoni159]

I must to use locktight when i am changing my rotors? And where to apply this only on the rotors bolts? On also on the callipers? And i must use tourqe wrench?

[Ruffus]

@Yoni159 welcome here!
On rotors and breakcaliper bolts its adviseable to use blue @Loctite because of vibrations on this items.
Torque wrench not necessarely if you have some experience with tools.

[Yoni159]

@Yoni159 welcome here!
On rotors and breakcaliper bolts its adviseable to use blue @Loctite because of vibrations on this items.
Torque wrench not necessarely if you have some experience with tools.

so how to tighten the bolts without tourqe wrench? 35nm is really tight?

[Ruffus]

What I said, if you have some experience, NO torque wrench.
If not, the likelyhood to mess up bolts or treads is high with torque wrench.
(for torque figures pls see pic)

[stuo]

A tip: If the rotor machine screws are difficult to remove due to the locktite, apply heat to the screw heads with a propane torch for a few seconds and they should easily break loose.

I agree with Rufus: snug them up without using a torque wrench unless you are not a confident "wrencher". The locktite will be your insurance.