scooter revs but doesnt move

[kymco God]

the subject says it all, got any idea whats wrong with it?
cheers guys

[ts1]

Remove vario cover, check the belt and then the clutch.

[kymco God]

cheers

[kymco God]

i have tryed that but still the same, every thing in that area is fine and works correctly, got anyother suggestions?
cheers

[ts1]

With the scooter on main stand, removed vario cover and engine running you should see the rear wheel spinning - or why not.
May be it seems to work fine trying on center stand, but there is not enough force tranferred to the rear wheel for real driving/acceleration. Clutch slipping or engine weak.

[TechGuy]

KG,

When you removed the CVT cover and started the bike... and rev'd the engine... What did you see?

[Whisper]

LOL!  If everything was fine it would work. 

Here's what we need to know:

On the centerstand, with the Variator cover off, and the engine revving:
- Does the front pulley move?
- Is the belt moving?
- Is the rear pulley moving?
- Is the rear tire moving?

From there, we can point you in the right direction!

[kymco God]

cheers for all the replys, and yes all of that is working...it is hard to explain over this forum without you seeing it, but when i pull the throttle all the way back, it revs but only moves a little, then it will just pick up again, sounds like something is slipping?
cheers guys

[Hoolander2]

I'd take the clutch off and look for worn out pads or binding pivot points on the pads.  The other thing to do is a compression check on the engine.  As ts1 said, it would seem to be either in the clutch or else a weak engine. 

[Whisper]

Best Case:  Clutch problems - Take it off and make sure everything moves as it should.  This would be my current bet.

Worst Case:  Your differential is destroyed - With the variator cover off, and the motor off, rotate the back tire by hand.  What does the rear pulley do?

[juice]

In one of K God's previous posts he was having trouble with the rear brake . Is it possible that he may have over adjusted the rear brakes resulting in the rear wheel not turning when the motor is reved ? Good luck .

[kymco God]

there is no play in the crank, it is all fine down in that dipartment, and i have new clutch pads on...lol got no idea what to do
thanks for your help

[kymco God]

Best Case:  Clutch problems - Take it off and make sure everything moves as it should.  This would be my current bet.

Worst Case:  Your differential is destroyed - With the variator cover off, and the motor off, rotate the back tire by hand.  What does the rear pulley do?

when it is on the3 center stand and i rev it, the rear wheel moves completely fine

[sparko]

possibly the rollers stuck inside the variator and not pushing the variator sides together? I don't think you mentioned whether or not the variator was moving in and out with the belt moving to the outside diameter of the variator.