Starter motor wont stop

[Peters]

Cool, I hope you're right. I did realize after I posted, if the short was before the starter the starter shouldn't be bad.

[zombie]

Zactactalee. It'll just be minor.

[Peters]

I installed the lifts at this AAA. Check out the second picture. Lifts are still standing. Oh yeah!

http://www.live5news.com/Global/story.asp?S=13714671

[Peters]

http://www.wltx.com/video/default.aspx?bctid=718529968001

[zombie]

The lifts that were installed with a Harbor freight impact driver no doubt! If it weren't a tragic story it would make a good commercial for them (Harbor Freight)

[Peters]

I love the electric impact from Harbor freight! We do use the impact to tighten the anchor bolts, but we also go back and torque them to 110 ft lbs with a Harbor Freight torque wrench .

So with the starter relay. Can I get one at the hardware store that will just plug right in to the factory harness? Or is it just a universal one? Will this work:
http://www.ebay.com/itm/STARTER-RELAY-for-KYMCO-DJ-50-DJW-DJY-DJX-Sniper-50-/270737259763?pt=UK_Motorcycle_Parts&hash=item3f0932bcf3
Doesn't say it's for a people but the terminals look the same.

[zombie]

Don't use the ebay one. You don't know how it is hardwired inside. Could short the system. Get a Bosch, or Cole hersey at any auto parts or hardware. Your "plug" will not match but you can remove the wires with the connectors from it , and plug them right onto the new relay. There will be one unused post on the relay when done.
http://www.google.com/products/catalog?client=opera&rls=en&q=bosch+30amp+relay&oe=utf-8&channel=suggest&um=1&ie=UTF-8&tbm=shop&cid=4055855830006904255&sa=X&ei=u76ET9zWKsG2twft4Oj_Bw&ved=0CH4Q8wIwAw

There is a schematic on the side of the relay showing what goes where.

[Peters]

"Your "plug" will not match but you can remove the wires with the connectors from it , and plug them right onto the new relay."

Gotcha!