tx 4 the post about the turn signal work around. i know that post is old (by kryden), but i hope someone helpful will see this. i can also be reached at stanleystankas@yahoo.com i have the 125 and the signals work fine but being clumsy around my scoot as well as an ill fated attempt at a theft i have broken off the signal housing under the seat box and replaced that entirely and also keep gluing back together a rear signal cup on the left side due to a bad guy trying to steal my scoot and not realizing i had a u lock on the back wheel so in spite he knocked it down. i am looking at something more flexible and while in a scoot shop i noticed a genuine scoot w/ some nice led rear signals that were more rubberized and gave a bit when contacted. that is really what i would like to swap out my signals w/ at least the rear because i tend to knee them. i am not very technically orientated obviously, but i do have the service manual on the scoot and w/ patience i would like to swap this out myself. thoughts on what might accomplish this situation? it appears kryden left the original signals in place 4 markers which might also be a possibility, however do not know if i can accomplish what he did. tx
