Checked the valve clearnces today and they seemed to be a bit tight, I only had a 0.05 feeler so I set it to that but so it was a little tight to get in and out.
Also found my set of little drills for pcb and was going to drill my 80 out to an 82 but found the drill would already fit in the jet so I went out to an 85 which just took a little push while spinning it and it was through.
Seems to run lovely now very quiet and ticks over at very low revs very steady.
I didnt take it for much of a run but it seemed ok a bit sluggish on choke but got more powerful as it warmed, I had the feeling it liked what i had done to it.
