Author Topic: Stalling out  (Read 2341 times)

TPococke

  • Pueblo, Colorado United States
  • Jr. Member
  • **
  • Posts: 66
  • "Life is Good!"
    • View Profile
Stalling out
« on: July 18, 2010, 10:30:56 PM »
Today my Xciting started stalling out at stops or near stops. I did do some high speed highway driving today and then came upon a traffic jam on the highway where it started the stalling. The Xciting is stalling often but always starts right up. It's not due for a tune up or check up for another 2500 miles. Any suggestions on what I should look at before I take to the shop?
Just remember, if the world didn't suck, we'd all fall off.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Stalling out
« Reply #1 on: July 18, 2010, 10:35:19 PM »
..well take a look at your air filter first...

..it's the easiest to correct, and most likely cause of unexpected idle problems, on a scoot with no previous issues...

..could be that it needs cleaning, or replacing...


peace
..every mod (action) necessitates a (reaction) mod..

Hoolander2

  • Hero Member
  • *****
  • Posts: 1180
    • View Profile
Re: Stalling out
« Reply #2 on: July 19, 2010, 03:32:59 AM »
Go to Wal-Mart and pick up a bottle of Star-Tron fuel additiive in the marine section.  And a long tip funnel.  Give her a double dose.  If you're fuel filter is starting to clog up or have sediment or water in the gas, that should clear it out. Keep using it right on. 

Then if it's still stalling, check or replace the fuel filter.  Not sure if you can get to it underneath without taking off the side skirt on that side. (left) 

TPococke

  • Pueblo, Colorado United States
  • Jr. Member
  • **
  • Posts: 66
  • "Life is Good!"
    • View Profile
Re: Stalling out
« Reply #3 on: July 20, 2010, 03:16:42 PM »
Thanks for the info wordslinger and hoolander2.
Just remember, if the world didn't suck, we'd all fall off.

sissy mary

  • Hero Member
  • *****
  • Posts: 968
    • View Profile
Re: Stalling out
« Reply #4 on: July 20, 2010, 03:35:31 PM »
Maybe adjust the idle? Mine idles around 2000 rpm. Also look into product called sea foam & add to gas. You may have gotten some bad gas?  :-*

Pnoy

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Stalling out
« Reply #5 on: July 23, 2010, 12:06:35 AM »
Today my Xciting started stalling out at stops or near stops. I did do some high speed highway driving today and then came upon a traffic jam on the highway where it started the stalling. The Xciting is stalling often but always starts right up. It's not due for a tune up or check up for another 2500 miles. Any suggestions on what I should look at before I take to the shop?

try to check carburator vacuum piston comp.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Stalling out
« Reply #6 on: July 23, 2010, 10:45:40 PM »
...sea foam works...cleared the people 50 i bought right up...

..it hadn't even been started in over 2 years....

..also, seafoam is aiding in the resurrection of my agility 50...

..had a clogged exhaust...
..every mod (action) necessitates a (reaction) mod..

jprestonian

  • Hero Member
  • *****
  • Posts: 1095
  • 2007 Kymco People 250, 2011 Honda PCX
    • View Profile
    • a scooter called wanda
Re: Stalling out
« Reply #7 on: July 24, 2010, 12:46:23 AM »
First, simplest thang to try first: Ride with the gas cap open.

If that fixes it, it's vapor lock.

The X500 has a small vent on the edge of the cap. If it's clogged, spray some carb cleaner in it, and maybe run some thin wire (like a guitar string) through it.
.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Stalling out
« Reply #8 on: July 24, 2010, 12:50:54 AM »
The X500 has a small vent on the edge of the cap

..so does the a50..

..aannd ..what he said too!..

 ;D

..every mod (action) necessitates a (reaction) mod..

jprestonian

  • Hero Member
  • *****
  • Posts: 1095
  • 2007 Kymco People 250, 2011 Honda PCX
    • View Profile
    • a scooter called wanda
Re: Stalling out
« Reply #9 on: July 24, 2010, 02:10:29 AM »
With the heat being the way it's been locally, I must get a half-dozen calls like this every week at the shop. 90% of the time, opening/removing the fuel cap (whichever is appropriate, depending on yer scooter) resolves the problem. It works like magic, they say. Heh.
.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Stalling out
« Reply #10 on: July 24, 2010, 02:15:16 AM »
...hot........                                   :-\

..testify brother!!

...they're predicting 100 tomorrow in this, my home town....
..every mod (action) necessitates a (reaction) mod..

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Stalling out
« Reply #11 on: July 24, 2010, 02:18:34 AM »
..i use a spray electrical contact cleaner to get th' gunk outta that vent...

..it dispells petroleates, has a nifty little straw and evaporates almost instantly into the atmosphere...

..tell Al G i said hey...lol...


peace
« Last Edit: July 24, 2010, 02:31:17 AM by wordslinger »
..every mod (action) necessitates a (reaction) mod..

jprestonian

  • Hero Member
  • *****
  • Posts: 1095
  • 2007 Kymco People 250, 2011 Honda PCX
    • View Profile
    • a scooter called wanda
Re: Stalling out
« Reply #12 on: July 24, 2010, 02:37:58 AM »
Yeah -- anything that'll bust up grime and evaporate will work. Shoot, just a guitar string will probably work. I had it happen to my P250 early in the season (first day it got to 87F); had it resolved as soon as I got to the shop, and borrowed the carb cleaner. *psssst!*
.

TPococke

  • Pueblo, Colorado United States
  • Jr. Member
  • **
  • Posts: 66
  • "Life is Good!"
    • View Profile
Re: Stalling out
« Reply #13 on: July 24, 2010, 02:28:14 PM »
Well I have been riding the 500 around the city all week and have had no stall outs. I didn't do anything to it (some times life just doesn't allow time). So until it happens again I'll just chalk it up to Gremlins. But when time allows I need to get my hands dirty and learn my machine.  ???
Just remember, if the world didn't suck, we'd all fall off.

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: Stalling out
« Reply #14 on: July 24, 2010, 04:57:52 PM »
I'm in a different part of the country,but there has been a rash of water in are fuel at some big name station. Try the sea foam for the easy solve.
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

An Error Has Occurred!

Call to undefined function split()