ps250 front turnsignals

[ispud]

I poked around a bit in the front plastic to see what the 2 clear lenses are.  I am guessing this is where the turn signals go on scooters other than USA models.  I have read other posts that talk about restoring the European style turn signals to get rid of the buggy eyed ones on the handlebars.  I did not see any wiring going to the built in location, but there was a cast metal housing that looked like it might be part of the European style on the back of the lens - there was a piece of tape over the hole that looks like maybe where a bulb would go.  I am guessing if this is the case a person could buy the bulb holder part of this assy and then wire it up and eliminate the bugeyes.  Any info on this would be appreciated.

Thanks,

>>

[zombie]

That's real simple, Just extend your current wireing to the location, and any auto parts shop will have the sockets you need. It is a ticket however if an eagle eyed trooper spots you

[wordslinger]

That's real simple, Just extend your current wireing to the location, and any auto parts shop will have the sockets you need. It is a ticket however if an eagle eyed trooper spots you

..or a tricked out A50...

wooo-woooooo....

[ispud]

I notice on the "ugly" p250 the front signals are built into the front plastic panel - this is about where my clear lenses are located.  I couldn't find pictures of the ugly p250 where they were supposed to be - someone could post some - no??

>>

[wordslinger]

I notice on the "ugly" p250 the front signals are built into the front plastic panel - this is about where my clear lenses are located.  I couldn't find pictures of the ugly p250 where they were supposed to be - someone could post some - no??

>>

..i think that was jprestonian"s scoot...check his posts...i think the link is in his signature...

peace