Derestricted bushing is in. Am hearing a light tinkling noise. Sounds like the starter gear is just a tiny bit engaged. Any ideas?
Take it apart, and do it again. The drive boss sits on the ramp plate. The drive face sits on the outside. (i know DUH) When you tighten the nut you MUST rotate the drive face to allow the belt to slightly climb up, and allow the drive face to sit flush, and square on the boss.
There is also a very thin shim washer that goes on the OUTSIDE pin of the starter bendix between the cvt cover, and the bendix. My GUESS is it fell off during the cover removal. If you can't find it on the ground look inside the cvt It may be laying in the case there somewhere. Otherwise you have to order one from Kymco. It's about 90 cents, and $73.47 shipping. (lol)