« previous next »
Pages: [1]

Author Topic: OK i may have found an Engine! however i need help ...  (Read 1067 times)

htcneil2

  • Full Member
  • ***
  • Posts: 196
    • View Profile
OK i may have found an Engine! however i need help ...
« on: August 08, 2015, 04:56:49 AM »
I have an 09, fuel injected.

Found an 07 engine. can i make it work?
Logged

mrjlube

  • Full Member
  • ***
  • Posts: 110
    • View Profile
Re: OK i may have found an Engine! however i need help ...
« Reply #1 on: August 08, 2015, 11:00:30 PM »
Well,are you going to keep the engine with the carb? Or will you convert to fuel injection?
Logged

htcneil2

  • Full Member
  • ***
  • Posts: 196
    • View Profile
Re: OK i may have found an Engine! however i need help ...
« Reply #2 on: August 10, 2015, 03:01:04 AM »
idblike to keep itbfuel injection
Logged

mrjlube

  • Full Member
  • ***
  • Posts: 110
    • View Profile
Re: OK i may have found an Engine! however i need help ...
« Reply #3 on: August 11, 2015, 02:25:25 PM »
You  would have to remove carburetor and replace with throttle body off the 09. You will need  all wiring and such from the 09 . Probably  could be done,but sounds difficult.
Logged

BettinANDlosing

  • Hero Member
  • *****
  • Posts: 2235
  • Carter Merz
    • View Profile
    • Columbia Scooters
Re: OK i may have found an Engine! however i need help ...
« Reply #4 on: August 11, 2015, 04:12:55 PM »
Could be done, but like stated above a lot of work. Stator needs to come from '09, exhaust from '09, intake and cylinder head from '09, throttle body from '09 etc etc etc etc. And going back to the carb version will be even harder.
Logged
2002 Kymco B&W 300; MRP 78MM "300CC", Naraku cam, Yoshimura rS3 exhaust, 17g Sliders, Yellow torque spring drilled airbox, stock carb #115 main #40 pj.

2001 "Yamaha" Zuma AKA MBK Booster; MHR OverRange, Dellorto 19mm BHBG, Polini "big" intake, RS-3 Rear shock, Stock cylinder.

Jeopardy4100

  • Jr. Member
  • **
  • Posts: 61
    • View Profile
Re: OK i may have found an Engine! however i need help ...
« Reply #5 on: August 12, 2015, 04:55:34 AM »
Any machining needed for the fuel pump?
Logged

An Error Has Occurred!

Call to undefined function split()
Back