08 Agility 125 Pilot Screw Location

[mt_100]

I have read about adjusting it and think I need to on my scoot, but for the life I of I cannot find it.

I have the manual and looked at the picture but when I look at the scoot on the side of the carb I don't see it.

Can anyone with an 08 Agility 125 help me out and give a good picture of how to find it? Is there a cover over it? If so how do I remove it?

I would be very grateful for some help.

[mt_100]

OK. Feel like an idiot. I was looking at the 50cc manual, not the 125. Once I looked at the right one I realized the screw was under the yellow cover and found it.

Was only turned out 1.75 turns. Adjusted it to 3.25 out and will see how things go.

[Vision]

Pilot screw...meaning idle control screw?

I don't know where it is either. Yellow cover?

I thought the manual suggests not touching it?

[mt_100]

Yeah, it is under the yellow rubber nipple looking thing on the left side of the carb towards the front. It says not to touch it, but sometimes you need to.

[beermak]

How did it perform 3.25 turns???

Enviado desde mi SM-G920I mediante Tapatalk

[mt_100]

Not well.

I ended up taking the carb off and cleaning it and the idle jet was clogged. Cleaned it out and put it all back together.

With some tinkering I got it running.

Now, with it warmed up it will run fine but seems like it wants to stall coming to a stop but doesn't. When I accelerated it right away feels like it will stall, and does 1 out of 10 times. Re-fires immediately and if I go it is fine.

So that tells me I am close. I am around 2 turns now and not sure if I am lean or rich but I am thinking a tad too rich.

[beermak]

Try to rise just a bit the idle screw and then play just a bit closing the mixture. I believe its a lill rich cause its stalling when giving gas from idle.

Enviado desde mi SM-G920I mediante Tapatalk