TIME FOR A BASIC TUNE-UP/ UPGRADE

[SUPER 9 MANN]

I have taken my cover off, which bolt do i remove.

[0BARK4322]

NOW REMOVE THE BOLT THAT HAVE THE ROUND DISK WITH TEETH ON IT---TO THE LEFT----IF YOU HAVE AN IMPACT WENCH IT WOULD HELP BETTER

[SUPER 9 MANN]

Ok it came off with no problem.

[0BARK4322]

JUST PULL THAT DISK OFF AND YOU WILL SEE THIS IN PICTURE--JUST PULL THAT BELT(FRONT ONLY) OFF AND MOVE IT OUT THE WAY

[SUPER 9 MANN]

Ok got it, just the front of the belt is out the way.

[0BARK4322]

NOW THE SAME PLACE WHERE YOU REMOVE THE BELT IS A CYLINDER THAT SLIDE OUT THE CAP MAY MOVE WITH IT BUT JUST HOLD IT AND TAKE OFF THAT CYLINDER WHICH IS THE BOSS DRIVE

[SUPER 9 MANN]

I have taken the boss out and it seem to have a different diameter at one end then the new one.

[0BARK4322]

YES IT DOES --THAT WHY YOUR SPEED WAS AT 30 MPH ONLY---IT WAS RESTRICTED WITH THAT SLEEVE---THE ONE ON RIGHT IS THE ONE THAT YOU SHOULD HAVE

[SUPER 9 MANN]

I have that one, now i am going to install it in the reverse i assume.

[0BARK4322]

OK--JUST MAKE SURE THAT YOU PUT THAT NUT BACK TIGHT AND TAKE YOUR TIME AND IF YOU HAVE ANY TEMPORARY LOK-TIGHT WOULD BE GOOD---AND !! WOW !! YOU CAN UPGRADE YOUR SCOOTER AND STAY IN TOUCH WITH YOUR COMPUTOR--GRRREAT--LET MY KNOW WHEN YOUR FINISH

[SUPER 9 MANN]

Ok, lets see what happen.

[wordslinger]

...make sure the variator stays in place!!!!

..and the rollers don't get  discombobulated!!!!!

 

[sidthesloth]

discombobulated!!!!!

 

[wordslinger]

...yeah f*ckin outta whack!!!

 

[sidthesloth]

AAAHHH!!!