« previous next »
Pages: [1]

Author Topic: short in lights  (Read 2380 times)

dreflu

  • Full Member
  • ***
  • Posts: 141
    • View Profile
short in lights
« on: May 07, 2010, 12:30:47 PM »
on my 2001 people my head and tail light just stopped working. the brake light and bright light are still working tho. this happened one time before and the next day when i went to fix it was working again. where do i begin to try and find the problem?
Logged

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: short in lights
« Reply #1 on: May 07, 2010, 01:09:03 PM »
..sounds like you might have a broken wire...

..below is a link to the ppl50 2t service manual, if you don't already have one..

..there is a wiring schematic in in that will help you in tracing down the problem...

...good luck!!!..breaks can be hard to find, especially if the symptoms come and go...


"http://www.scribd.com/doc/18774028/Kymco-People-50-EN"
Logged
..every mod (action) necessitates a (reaction) mod..

dreflu

  • Full Member
  • ***
  • Posts: 141
    • View Profile
Re: short in lights
« Reply #2 on: May 07, 2010, 04:41:14 PM »
the brake light works. its the back light and head light that stays on when the motor is running that is out. i guess im gonna have to trace wires. it'll never run again
Logged

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: short in lights
« Reply #3 on: May 07, 2010, 04:45:00 PM »
..you'll do fine dre...

..and when you're done, you'll know all about you lighting system!!

 ;D
Logged
..every mod (action) necessitates a (reaction) mod..

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: short in lights
« Reply #4 on: May 07, 2010, 06:56:04 PM »
I would start at the stator. Check/clean every connection, right pu to the bulb. No doubt you will find it!
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

Shaka

  • Hero Member
  • *****
  • Posts: 1660
    • View Profile
Re: short in lights
« Reply #5 on: May 07, 2010, 10:47:07 PM »
Check the voltage regulator also! ;)
Logged

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: short in lights
« Reply #6 on: May 08, 2010, 03:31:36 AM »
I think his regulator does all the other lights. I believe the head light is run straight from the stator on AC. Most likely a dirty connection or bad bulb.
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

Shaka

  • Hero Member
  • *****
  • Posts: 1660
    • View Profile
Re: short in lights
« Reply #7 on: May 08, 2010, 03:37:58 AM »
Quote from: zombie on May 08, 2010, 03:31:36 AM
I think his regulator does all the other lights. I believe the head light is run straight from the stator on AC. Most likely a dirty connection or bad bulb.

I think you may be right on that.  I think the headlight and running lights are on the same circuit which runs direct on AC.  If the stator is bad I don't think the other lights would work.  Maybe a bad switch?  Wait just thought about that.  The brake lights would be running directly off the battery.  Yep, check the stator.  I'd do the regulator also just to be sure though.
Logged

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: short in lights
« Reply #8 on: May 08, 2010, 03:48:30 AM »
WD-40 IN the switch... The most obvious is the least seen.    " Maybe a bad switch? "
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

dreflu

  • Full Member
  • ***
  • Posts: 141
    • View Profile
Re: short in lights
« Reply #9 on: May 08, 2010, 07:05:40 PM »
thanks. i had all the front plastic off playing with the wires and it did nothing. i read your post about the stator shook those wires and the lights are back on ;D thanks. i'm not gonna mess with it unless the go out again
Logged

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: short in lights
« Reply #10 on: May 08, 2010, 07:17:26 PM »
...woo-hooo!!!!


 ;D :D :) :D ;D
Logged
..every mod (action) necessitates a (reaction) mod..

zombie

  • You never know do ya!
  • Hero Member
  • *****
  • Posts: 13870
  • Close enough to get the idea!
    • View Profile
Re: short in lights
« Reply #11 on: May 09, 2010, 03:18:03 AM »
"If the lights go out just jiggle the cord"   "Throw a Kit" by Hollywood Holt
Logged
"They have nothing in their whole imperial arsenal that can break the spirit of one Irishman who doesn't want to be broken."   Bobby Sands...

Shaka

  • Hero Member
  • *****
  • Posts: 1660
    • View Profile
Re: short in lights
« Reply #12 on: May 09, 2010, 03:56:20 AM »
LMAO!!!! ;D
Logged

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: short in lights
« Reply #13 on: June 04, 2010, 11:06:42 PM »
Love the vid,anyone else playing with your wiring do not unplug the regulater and start it,I did blew every light in the bike,not recomended!!!  ;D
Logged
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

An Error Has Occurred!

Call to undefined function split()
Back