« previous next »
Pages: [1]

Author Topic: UXV 500i windscreen (homemade)  (Read 829 times)

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7764
  • West Tennessee, USA
    • View Profile
UXV 500i windscreen (homemade)
« on: July 05, 2016, 09:20:23 PM »




This is my attempt at a windscreen for the 500i. The top is the $7.95 US that one of you guys found. It IS snug but fits! The screen has a slight curve to keep it from vibrating.

Karl
« Last Edit: July 05, 2016, 09:27:06 PM by CROSSBOLT »
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

airshot

  • Hero Member
  • *****
  • Posts: 1164
    • View Profile
Re: UXV 500i windscreen (homemade)
« Reply #1 on: July 06, 2016, 12:15:54 AM »
   Actually looks quite nice. You might find it gets a little warm in there in the summer heat and might want to consider a half windshield at least that was my take. Curious about whether you used the clamps to hold the windshield on or whether you screwed it directly to the roll bars?  I used the clamps for easy removal ...just in case.
Logged

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7764
  • West Tennessee, USA
    • View Profile
Re: UXV 500i windscreen (homemade)
« Reply #2 on: July 06, 2016, 01:22:14 AM »
Drilled and tapped for 1/4-20 stainless machine screws, red Loctite to keep 'em there. Rubber washers and short section of neoprene tubing to cushion the  1/4"poly-carbonate. Thank you!

Stig, over on the scooter side, took the time to coach me on posting those pictures. Without him this post would not have been possible!

Karl
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

An Error Has Occurred!

Call to undefined function split()
Back