ACF-50 corrosion treatment....Yesterday...
Used soft brushes and 'green' cleaner to clean as much as I could. Rinsed with hot water spray.
Let dry....then used the can's spray wand ,
but mostly the soft old paintbrush to apply the ACF-50 product.
Applied to exhaust, engine, CVT cover, every external panel screw, chrome crash bars, shocks, etc. Careful to keep it off of the tires and brake discs. After 1/2 hour wiped it down.
It did smoke pretty good on my first ride this morning - but was expecting this - and 15 mins later did not notice any smoke at a stop light. The smell lingers on at the end of one ride, but no smoke.
Tomorrow, I will remove the seat bucket and treat under there.
Found the most corrosion to be rust on the center stand cross-bars.
Stig
