Before you buy them check the thickness. You need .030-.033, Any thicker will ruin your idle circuit. Thinner will ruin your top end. It is a balance act just like the cvt. The epoxy can be found almost anywhere. It is the type in the 2 barrel syringe looking thingy. I use the SLOW cure type, and give it over night to cure. Just put a bit on your finger tips, and wipe it over the raw edge. You don't want any extra on the reeds, as it will affect the spring action in them. BE SURE to keep ALL the edges/cuts ROUNDED. You dont want any sharp intersections, as that would be a place for a crack to start. A little emory cloth will round up all the angles. This mod is about equal to doing rollers, as far as results go. Its worth the effort.
