Author Topic: Final straw :-(  (Read 2809 times)

yogi

  • Newbie
  • *
  • Posts: 25
    • View Profile
Final straw :-(
« on: July 05, 2010, 07:13:51 PM »
Right guys after having the Super 9 for two years ive never got to the bottom of the bog down on acceleration.

When I got the scoot it never had a service in 23,000km :-O So I went to work replacing as follows.

Belt
Variator
Rollers
Clutch
Mallosi white torque spring
Leo vince TT exhaust
And general maintenance over the bike.

Even after all of that and resetting the carb back to factory setting and tweaking with new plugs etc still the same?

Every pull away is the same from the lights twist the throttle and you get a bog down for around 2-3 seconds which at the lights is awfull seeing as though I was at the lights with  a Standard peugeot the other day and it wasn't until 30+ I got it back easily lol.

I really am getting to the end here as this one problem is really getting me down because it spoils the rest of the bike :-(.

So the question is, am I missing anything obvious ?

Oh BTW ive done a compression check also and that  came out fine at.
Any helps appreciated again guys :-)

jbcinzio

  • Jr. Member
  • **
  • Posts: 79
  • I was the second gunman on the grassy knoll....
    • View Profile
Re: Final straw :-(
« Reply #1 on: July 06, 2010, 03:53:17 PM »
Hi Yogi,

I would check for a sticking piston(slide) in the Carbi.
When I disassembled mine, I noticed that the slide was painted black, and that some patches were wearing off as the piston moves up & down.

Just a thought....

Josh
This message was posted using 100% recycled electrons.

axy

  • Hero Member
  • *****
  • Posts: 2210
    • View Profile
Re: Final straw :-(
« Reply #2 on: July 06, 2010, 06:20:59 PM »
Nobody mentioned CDI?
---
Kymco People GT300i 2017 ABS Euro4
Kymco Agility 125 2008

(Past: Kymco People 250S, Piaggio Beverly 200, Kawasaki ZR-7S, Yamaha TW125, Kymco Cobra Cross 50, Peugeot Zenith 50, Piaggio NRG 50 mc2 72 cc Naraku kit)

yogi

  • Newbie
  • *
  • Posts: 25
    • View Profile
Re: Final straw :-(
« Reply #3 on: July 06, 2010, 07:07:56 PM »
Nobody mentioned CDI?
Do they suffer from this ?

sidthesloth

  • Hero Member
  • *****
  • Posts: 2313
  • Kymco ZX50
    • View Profile
Re: Final straw :-(
« Reply #4 on: July 06, 2010, 11:09:51 PM »
It sounds like carb. tuning to me, may be getting too much fuel at initial opening of the throttle, if you have an adjustable needle try lowering it one notch and note the difference, or, it might be time to sit down and give the carb. a good thorough clean.
ZX50, 47mm cyl. kit, TZR50 CDI. Michelin Pilot Sport tyres,
Next performance mod; pumping the tyres up.

Shaka

  • Hero Member
  • *****
  • Posts: 1660
    • View Profile
Re: Final straw :-(
« Reply #5 on: July 07, 2010, 12:57:48 AM »
You could always sell it to me!  ::)  It sounds like a carb related issue!  Worse come to worse, just throw an aftermarket carb on it! ;)

yogi

  • Newbie
  • *
  • Posts: 25
    • View Profile
Re: Final straw :-(
« Reply #6 on: July 07, 2010, 06:17:22 AM »
You could always sell it to me!  ::)  It sounds like a carb related issue!  Worse come to worse, just throw an aftermarket carb on it! ;)
Are there any aftermarket carbs which will bolt straight up to the super 9 a/c ? at present there is a Keihin carb one there.

Also there is a second hand Keihin carb on good old Ebay, is it worth spending on that or a new one?

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: Final straw :-(
« Reply #7 on: July 08, 2010, 11:38:28 PM »
Nobody mentioned CDI?

..axy said...



..de-restriction of the cdi!??

..has it been done??
 
 
..every mod (action) necessitates a (reaction) mod..

yogi

  • Newbie
  • *
  • Posts: 25
    • View Profile
Re: Final straw :-(
« Reply #8 on: July 09, 2010, 05:20:43 PM »
Nobody mentioned CDI?

..axy said...



..de-restriction of the cdi!??

..has it been done??
 
 

Didn't think it could be done on an aircooled 9 ?

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: Final straw :-(
« Reply #9 on: July 09, 2010, 05:37:14 PM »
The bog off the bottem is usualy fuel related,dirty jets,too small a needle jet,fuel not flowing from tank.With the pipe try a richer needle setting(raise the needle,lower the clip)If it's more of a sputter your too ritch on the bottem jetting.Did you do anything to the air box?
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

An Error Has Occurred!

Call to undefined function split()