Valve tool

[Ernst]

 Every time I adjust the valves on my P250S I wish I had the proper tool to hold the adjuster in place instead of needle nose pliers.

 I have not sourced the proper valve tool and service manual doesn't give a part number for it.  Has anyone found or know where I can get one?


Doh! Ebay!

Okay I ordered a set for $15 8mm,9mm and 10mm

Thanks anyway.. Got post happy.

[de dee]

Every time I adjust the valves on my P250S I wish I had the proper tool to hold the adjuster in place instead of needle nose pliers.

 I have not sourced the proper valve tool and service manual doesn't give a part number for it.  Has anyone found or know where I can get one?


Doh! Ebay!

Okay I ordered a set for $15 8mm,9mm and 10mm

Thanks anyway.. Got post happy.

  THE ADJUSTER IS A sqare bolt head  just the right size as a # 2 robertson screw driver with the tip removed, 

[Ernestt]

i used a square headed screw and bent it to a 90 degree angle i didn't pay anything for it i have a coffee can full of them

[Ernst]

I got my  set and plan to adjust valves tomorrow.  I will see if I have the right one.

[RatBob]

I use the pliers end of my stripper/crimper, never had a problem that I saw the need for a special tool, but I might try the screw idea since it's free.