First - go in and tell your significant others that you love them. Because, after wrestling for 1/2 hr to re-fit each new bulb you are
not going to like
anybody!
I used the AMBER bulb.
In the glove box...
Remove the two screws. Then stick screwdriver in one of the holes of this black panel and pull panel towards the center of the scooter to release it. (pull right panel towards the left. Pull left panel towards the right)
You'll have this...
Turn the front wheel away - reach under here and grab the rubber base of the bulb and pull it gently out.
Wiggle, pull, wiggle -
gently on the rubber base.
I use 2 finger tips and pinch it out.
Feel around - find the wire that has your bulb on it.
Bring the bulb up through the glove box opening.
Replace this bulb with your LED. Turn on key to insure it's connected in there.
Now the tricky bit. Fish the new bulb back to the socket opening, reach under and push it back into the hole (with your two finger tips)
I use a little lube on the rubber collar of the bulb holder to ease the re-install.
Take your time - insure that you don't push the bulb out of its holder - turn on the key to insure bulb lights!
I swear - I'd rather check the valves than do this bulb replace! Getting that little sucker back in there with my Easter Ham sized hands is not fun.
If anyone has found a easier way - please report it here!
Stig
Yeah, it's bright!
