Author Topic: No spark  (Read 5073 times)

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: No spark
« Reply #30 on: September 02, 2010, 12:30:20 AM »
 Ah another posibility ha ! wiring not my strong point  ::)
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: No spark
« Reply #31 on: September 02, 2010, 12:33:19 AM »
..i'm just not sure where that wire goes...all the ones from that switch seem like they must be connected...just from tracing them out...hhmmmmmm.....
..every mod (action) necessitates a (reaction) mod..

jswalls110

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: No spark
« Reply #32 on: September 02, 2010, 12:52:09 AM »
Yea, I know. Strange. I think I may send an email to Kymco tomorrow and see if I get a response.

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: No spark
« Reply #33 on: September 02, 2010, 12:58:21 AM »
  Is it possible someone had an alarm system on it at one time. Does it look to be factery wiring? Some people add a toggle switch at glove box or under seat to make it harder to steal.
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

jswalls110

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: No spark
« Reply #34 on: September 02, 2010, 01:01:56 AM »
Actually, I won this in a Relay for Life raffle in 2008, and it was new from a dealer. So I am owner #1.

sidthesloth

  • Hero Member
  • *****
  • Posts: 2313
  • Kymco ZX50
    • View Profile
Re: No spark
« Reply #35 on: September 02, 2010, 01:04:33 AM »
On ZX50, the B/W goes to the cdi.
ZX50, 47mm cyl. kit, TZR50 CDI. Michelin Pilot Sport tyres,
Next performance mod; pumping the tyres up.

jswalls110

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: No spark
« Reply #36 on: September 02, 2010, 01:06:05 AM »
I don't know if this is important, but after the connector, the wire is Blue/Yellow.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: No spark
« Reply #37 on: September 02, 2010, 01:07:53 AM »
..dunno the orientation, but the drawing i have shows all the wires to th same connector...
there:

black becomes blk/blu to a 7amp fuse and to the cdi..
blue/yellow to the pulsar and cdi
green to several lamps
red to the battery and voltage regulator
green to the ignition coil ground...
..every mod (action) necessitates a (reaction) mod..

sidthesloth

  • Hero Member
  • *****
  • Posts: 2313
  • Kymco ZX50
    • View Profile
Re: No spark
« Reply #38 on: September 02, 2010, 01:10:05 AM »
Is it to shut down the engine?
ZX50, 47mm cyl. kit, TZR50 CDI. Michelin Pilot Sport tyres,
Next performance mod; pumping the tyres up.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: No spark
« Reply #39 on: September 02, 2010, 01:14:07 AM »
Is it to shut down the engine?


...lol..apparently!!

 ;D
..every mod (action) necessitates a (reaction) mod..

sidthesloth

  • Hero Member
  • *****
  • Posts: 2313
  • Kymco ZX50
    • View Profile
Re: No spark
« Reply #40 on: September 02, 2010, 01:15:21 AM »
OOOPS!!!
ZX50, 47mm cyl. kit, TZR50 CDI. Michelin Pilot Sport tyres,
Next performance mod; pumping the tyres up.

art

  • Hero Member
  • *****
  • Posts: 1682
    • View Profile
Re: No spark
« Reply #41 on: September 02, 2010, 01:16:42 AM »
 ;D   ;D    ;D   :o
Kymco peoples too many ;) I'm not an expert just a full time hobbiest.

jswalls110

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: No spark
« Reply #42 on: September 02, 2010, 01:17:32 AM »
And it does a VERY good job doing it!

I see no side effects so far from not having it connected, but I know it has to do something.

wordslinger

  • Hero Member
  • *****
  • Posts: 10766
  • undead primate
    • View Profile
Re: No spark
« Reply #43 on: September 02, 2010, 01:22:04 AM »
..all your lamps work??
..every mod (action) necessitates a (reaction) mod..

jswalls110

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: No spark
« Reply #44 on: September 02, 2010, 01:22:41 AM »
yup.

An Error Has Occurred!

Call to undefined function split()