« previous next »
Pages: 1 ... 8 9 [10] 11 12

Author Topic: KYMCO like 200 keeps dying  (Read 15739 times)

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7763
  • West Tennessee, USA
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #135 on: April 04, 2020, 08:01:54 PM »
Quote from: big blue on April 04, 2020, 06:38:46 PM
Could not find specs for the Like but fuel pump pressure for the People GT 200i is 3 BAR or 45 PSI.
The pressure I posted is actually from the DT300i service manual! Figured it would be close enough since all the fuel pumps seem the same...
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7763
  • West Tennessee, USA
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #136 on: April 04, 2020, 10:29:04 PM »
Whiskers, you GOT this! That fuel pump is so easy to get to. I will bet there is a small piece of trash stuck in the relief valve bypassing fuel back to tank. That's probably where the bubbles originated!
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14689
  • Rural Ohio
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #137 on: April 05, 2020, 08:46:49 PM »
In case you have to investigate and/or replace the LIKE's fuel pump:

The stock LIKE200i fuel pump has "no serviceable parts" according to my manual.
The 0 ring is supposed to be replaced each time you remove the pump from the tank.
No one sells the giant 0 ring - it is attached to the new $+200 pump assembly.

The pump must be eased out of the tank with some effort (like a cork in a bottle) and I returned it with a bit of silicone lube all around.  Taking the measurements of the stock pump and after a phone contact with the tech. - I purchased a replacement 30mm HIGHFLOW pump. (ebay advert. said it would fit a Suzuki motorcycle) It's been working great in my 2012 LIKE200i for 7 years.

KYMCO holder accepts a pump this size.... 30mm X 70mm
https://www.highflowfuel.com/i-28316344-quantum-intank-efi-fuel-pump-for-hyosung-ms3-250-scooter-2010-2020-replaces-hyosung-15100hp8800.html

Basically 'plug-and-play' Take a photo if need be to get all connections back in proper places.
Match the wires and hoses, place in the stock KYMCO pump holder and reinsert it back into the tank. Bolt it up and check for leaks.


All kinds of pumps are available - I paid a bit more for the HighFlow as I don't want to repeat this procedure!

Stock pump is in this metal and plastic holder.....which you will re-use!


New HighFlow pump installed in holder.








(This has been edited following loss of photos in orig. post)

Stig
« Last Edit: April 06, 2020, 02:51:42 PM by Stig »
Logged
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7763
  • West Tennessee, USA
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #138 on: April 05, 2020, 09:10:00 PM »
There! Stig's way better service manual than Kymco!

The 200 bucks from Kymco is because they list the whole assembly. Stig did the legwork to find just the pump! He cheapo Joe like me! He's a genius!
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

whiskers626

  • Jr. Member
  • **
  • Posts: 68
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #139 on: April 17, 2020, 02:20:23 PM »
Quick question on fuel pressure wondering if anyone knows. The small hose from the pump to the outlet inside the tank was deteriorated, I replaced it and now my fuel pressure is perfect while the pump is running when you turn the key on, as soon as the pump stops running the pressure drops back to zero, is it supposed to do that?
Thanks
Logged

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7763
  • West Tennessee, USA
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #140 on: April 17, 2020, 02:36:57 PM »
See? You the genius! We were all hot for you to replace the pump and YOUR investigation shows a $.98 hose is the culprit!

Yes, the pressure drops to zero whan the pump shuts off. Normal.

So happy for you finding this! Now you have been farther into the fuel system on this model than anyone here! Your discovery leads to one more thing on the troubleshooting checklist. This feedback is vital since this system is typical of most EFI setups on these types of machines. Your results SHOULD be in the service manual!
« Last Edit: April 17, 2020, 02:40:55 PM by CROSSBOLT »
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

whiskers626

  • Jr. Member
  • **
  • Posts: 68
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #141 on: April 17, 2020, 06:12:52 PM »
Ok yay, need more help, I got this damn thing running, here’s the catch it will only run and crank if I open the throttle full blast, soon as I let off the throttle it dies, we are so close , please help me figure this o w out.
Thanks in advance
Logged

CROSSBOLT

  • Hero Member
  • *****
  • Posts: 7763
  • West Tennessee, USA
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #142 on: April 17, 2020, 06:57:15 PM »
Initialize again.
Logged
Karl

Three motorcycles 1960-1977 (restored a 1955 BSA)
Agility 50
Yager 200i
Downtown 300i
Navy tech, Ships Engineer, pilot and aircraft mechanic

whiskers626

  • Jr. Member
  • **
  • Posts: 68
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #143 on: April 17, 2020, 07:34:25 PM »
What does initialize again mean????  :-\
Logged

big blue

  • Hero Member
  • *****
  • Posts: 1183
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #144 on: April 17, 2020, 08:32:15 PM »
Quote from: whiskers626 on April 17, 2020, 07:34:25 PM
What does initialize again mean????  :-\

Here is the page from the Like 200i manual for initializing...
Logged
2012 Kymco Like 200i LX (Sold)  Salem, Oregon USA

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14689
  • Rural Ohio
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #145 on: April 17, 2020, 08:34:45 PM »
Quote from: whiskers626 on April 17, 2020, 07:34:25 PM
What does initialize again mean????  :-\
On your cyclepedia.com
Go to fuel system, click on Self Diagnosis

Follow all the steps listed below this bold heading...
Self-Diagnosis Reset Procedure
Try all of them.

Stig
Logged
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14689
  • Rural Ohio
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #146 on: April 17, 2020, 08:40:44 PM »
Quote from: big blue on April 17, 2020, 08:32:15 PM
Here is the page from the Like 200i manual for initializing...
Curious here big blue - what manual is that from?
Does not look like either my printed cyclepedia or my online version.
Thanks, Stig
« Last Edit: April 18, 2020, 12:33:01 AM by Stig »
Logged
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

big blue

  • Hero Member
  • *****
  • Posts: 1183
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #147 on: April 18, 2020, 12:04:26 AM »
It's an old online factory PDF manual that was available for free. I have a copy on my computer.  ;)
Logged
2012 Kymco Like 200i LX (Sold)  Salem, Oregon USA

whiskers626

  • Jr. Member
  • **
  • Posts: 68
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #148 on: April 18, 2020, 02:04:52 PM »
Ok everyone I put the new fuel pump in, good pressure, did all the resets etc. it will crank and start if I hold the throttle wide open and then it will run as long as I have the throttle almost 1/4 to 1/2 turn but will not idle, I’m not an expert but something is telling me injector, I took it off again and cleaned it, so that’s where I am.
I just know by the end of the weekend this thing will be working and I will have the wind in my hair once again.
Logged

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14689
  • Rural Ohio
    • View Profile
Re: KYMCO like 200 keeps dying
« Reply #149 on: April 18, 2020, 02:14:59 PM »
Can you button it up and ride it very briskly near enough to your house that if it dies it won't give a stroke if you have to push it home?
Perhaps that poor scooter just needs some exercise....and maybe a fresh tank of SHELL premium gas to flush out your injector and fuel line?
If it does throw an embolism. ...you need to be close to the house......
Things are looking good!
Meanwhile we'll look into "scooter won't idle"
Stig
Logged
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

An Error Has Occurred!

Call to undefined function split()
Back