what is the size of the flywheel nut

[B3N]

I lost my nut  so what is the size of the nut at the end of the crank shaft on the flywheel side uxv 500i 2012 thank you

[CROSSBOLT]

You may not get many responses! I have  UXV500i and have never yet had a need to take the CVT apart.

[B3N]

i talk about the nut on the driver side where is the flywheel the nut is under the case for hand crank

[CROSSBOLT]

i talk about the nut on the driver side where is the flywheel the nut is under the case for hand crank

I am sorry but I did not understand any of that. Also, I have not had to disassemble anything on the UXV.

[CThacker]

I lost my nut  so what is the size of the nut at the end of the crank shaft on the flywheel side uxv 500i 2012 thank you

Where you able to figure out the size?  Send me a picture of your flywheel as I am about to open up the crank case to ensure my piston is at TDC.  I can tell you what the size it after that.

[300winchester]

Don't open up or take off side cover just to check to see if your piston at TDC, just take out the inspection plug, I sent you the manual and posted pics.  if you take that side cover off youll need a new gasket and your hours down with labor, if your after that 19mm socket nut, that on the side of the stator cover, there is a big allen that goes into in, its about a 3 " circle diameter, take that off you will see the nut, my flywheel had a sprag clutch on it, so only turn one way.

[300winchester]

https://www.manualslib.com/manual/2032784/Kymco-Uxv500i.html?page=818#manual

page 818

this manual will also show you what plug to take out to inpect for flywheel timing etc

[300winchester]

Nut size 
Page 831

N.F.M14