Some people don't like the fact there is no engine braking with a two stroke but I think it's a plus. You don't get the diving of the front end when you let off the throttle.
This is a prejudice that originates from old 2 stroke engines with old construction, that also had pre-mix oil and gasoline mixture.
In that case, using engine braking would cause premature wear due to inadequate lubrication of the engine during engine braking.
Almost all bikes in the past 20 years do not use pre-mix but have separate gasoline and oil tanks.
Internal friction of the engine enables engine braking and,
ceteris paribus, it is determined by engine's compression ratio.
Usually Kymco's small 2 stroke engines have compression 1:7-1:8 while small 4 stroke engines have 1:8-1:9.
So, they will pretty much engine brake the same, regardless of 2 or 4 stroke composition of the engine.Whoever drove 2 and 4 stroke motorcycles can from experience notice the same.
If you are from USA, I think you did not have 2 stroke cars in the past.
In Europe we had just a few (usually from the Eastern block) and they had special system that allowed the driver to use or not engine braking for short periods of time, in order to prevent engine damage (all such cars were pre-mix at the time, I am referring to East German Wartburg and Trabant cars).