Author Topic: Using a pencil tire pressure gauge?  (Read 1665 times)

Stig / Major Tom

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 14693
  • Rural Ohio
    • View Profile
Using a pencil tire pressure gauge?
« on: July 25, 2013, 01:35:29 PM »
Bought a new tire pressure gauge the other week ($1 at Malwart). One of those pencil shaped ones... the round analog type tire gauge I have for the cars wouldn't fit in the space available without difficulty when checking the back tire of my LIKE 200i. Tested it against my old pencil gauge - and was glad I tossed for a new one - way different readings vs the old one.

 Yesterday I decided to bite the bullet and buy a nice digital tire gauge. $15.
Checked the tires again with this new digital gauge and found I was running on underinflated tires for a week.
Pencil gauge read : 25 psi and 30 psi (F/R) (correct per owner's manual)
Digital gauge read : 18.5 psi and 24.5 psi !

Went to an air tank with an accurate analog gauge built into it, and re-measered with both gauges. Sure enough, the pencil gauge was way off.
Hmmmm.  Lesson learned, again.....I keep having to relearn this lesson. You get what you pay for...usually.


LIKE floormats~!
Boston Strong
Rural Ohio

And, I'm feeling a little peculiar.

wheelsoffreedom76

  • Jr. Member
  • **
  • Posts: 84
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #1 on: July 25, 2013, 02:41:49 PM »
 I ran into the same situation. I keep a pencil type in the RV, and small dial types on the bicycles and motorcycles. I used the one from the mountain bike to set the pressure on the AG50 as either the dealer put too much, or shipped with 48 lbs in the tires. My dial gauge was actually reading about 8 psi higher than actual. I never noticed due to running 65 psi on the bicycles (8 psi diff wasn't a biggy) but when shooting for 25 psi, ending up with 17 the front tire was a little squishy. I too went to my portable tank to see which gauge was accurate and it ended up being the slime brand pencil type.

ophelia

  • Sr. Member
  • ****
  • Posts: 394
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #2 on: July 25, 2013, 03:07:53 PM »
I found Slime brand pencil gauges work well too, when I check them against a known good gauge. Sometimes cheaper gauges work too, but I have to write down a correction factor of a few psi. Hassle.
2011 Kymco Downtown 300i

Vivo

  • Hero Member
  • *****
  • Posts: 4980
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #3 on: July 26, 2013, 01:57:07 AM »
I use the pencil type and what I did was just mark with a red ink marker the correct pressure reading.. This way, I don't have to "read" the gauge every time I check... I just look at the mark...

Calothrix

  • Sr. Member
  • ****
  • Posts: 341
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #4 on: July 26, 2013, 04:35:09 AM »
How about the accuracy of the electronic digital gauges?  One came with my work vehicle but I have no idea if it is any more accurate than the mechanical pressure gauges.

Vivo

  • Hero Member
  • *****
  • Posts: 4980
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #5 on: July 26, 2013, 05:29:08 AM »
How about the accuracy of the electronic digital gauges?  One came with my work vehicle but I have no idea if it is any more accurate than the mechanical pressure gauges.

Sometimes, when you really need it... batteries are dead...

Although mechanical ones are not that accurate... they're quite reliable and durable

ophelia

  • Sr. Member
  • ****
  • Posts: 394
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #6 on: July 26, 2013, 07:49:56 AM »
How about the accuracy of the electronic digital gauges?  One came with my work vehicle but I have no idea if it is any more accurate than the mechanical pressure gauges.

Test against a gauge that you know is accurate at the pressures that you are measuring! Then if the gauge is significantly off, you can return it. I imagine an electronic gauge may go out of calibration just like a mechanical gauge. Only way to know is to test.

I have a handful of different mechanical gauges both standalone and on pumps. They're all quite close in measurement.
2011 Kymco Downtown 300i

Vivo

  • Hero Member
  • *****
  • Posts: 4980
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #7 on: July 26, 2013, 07:55:58 AM »
Sometimes I just kick the tires and ride....  ;D

CosmoKorny

  • Sr. Member
  • ****
  • Posts: 477
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #8 on: July 26, 2013, 12:32:36 PM »
Sometimes I just kick the tires and ride....  ;D

Lol I live in the real world too.  :)
Normal is boring.

2006 Kymco Xciting 250

08087

  • 09' Peoples 200, NJ
  • Hero Member
  • *****
  • Posts: 1373
    • View Profile
Re: Using a pencil tire pressure gauge?
« Reply #9 on: July 29, 2013, 12:50:46 AM »
Maybe it's the $1.00 you spent when you should have spent $5.00, just sayin.
This posting is provided “AS IS” with no warranties either expressed or written and confers no rights. You assume all risk for your use, the author is not responsible for your inability to understand logic, ambiguous references, sarcasm, the imaginary friends living inside my head or William Shatner

An Error Has Occurred!

Call to undefined function split()